Job Cost Accounting for Contractors: The Difference Between Busy and Profitable

A general contractor came to us in October doing about $1.4M in revenue. Crews booked solid, deposits landing every week, the business checking account never dipped below comfortable. Then we ran his year-end projection and he was looking at a tax bill bigger than he thought his entire profit was. His first question is the one we hear most. If the account looked fine all year, where did this come from? What he was missing is the thing most generalist CPAs never build for a builder: job cost accounting for contractors.

Your bank account is not your profit

Cash in the account tells you what came in, not what you kept. A contractor’s deposits are a mix of progress billings, draws on jobs that aren’t finished, and money collected on work that hasn’t started. Some of it is already spent on materials sitting in a garage for next month. Some of it belongs to a sub you haven’t paid yet. A healthy balance can sit right on top of a job running fifteen points under bid, and you would never catch it from the bank feed.

That is why a contractor can feel busy and flush all year and still get blindsided in April. Volume hid the margin the whole time.

What job cost accounting actually is

Job cost accounting means tracking revenue and costs by job instead of in one pile for the whole company. Every dollar of labor, materials, equipment, and subcontractor cost gets assigned to the project it belongs to. Instead of a single company report that says revenue $1.4M, costs $1.1M, you get a real number for each job: what it brought in, what it cost, and what it actually netted.

For a trade business that is the whole difference between knowing you are busy and knowing you are profitable. Most generalist CPAs never set it up, because they treat a contractor like any other small business. They sort expenses for the return and move on. That is fine for a retailer. It breaks down for a builder running six jobs at once with cash moving between all of them.

Why job costing is where tax strategy starts

Every year-end move depends on knowing your real number, and job costing is where that number comes from.

A tax projection is a good example. It is only as honest as the profit figure behind it, and a projection run off a bank balance is planning against a mirage. Equipment timing is another. Deciding whether to buy the truck or the excavator before December 31 only pays off if you know you had a strong-profit year to absorb the deduction. On a year that looked busy but ran thin, that same purchase drains cash you are going to need in February.

Then there is the work in progress. On longer jobs, the amount you have billed and the amount of work you have actually finished rarely line up. Bill ahead of the work and you are holding cash that is really next year’s income. Fall behind and you have done work you have not been paid for yet. Without costs tracked by job, none of that is visible, and it swings your taxable income in both directions. This is what real construction business owner tax planning runs on, and it is impossible to do from a lump-sum P&L.

What to do before December 31

Start by getting every cost assigned to a job, not dropped into a general bucket. Labor, materials, equipment hours, and subs each tie to the project that incurred them.

Separate your direct job costs from overhead, so the margin you read on each job is the real one and not your office rent smeared across everything.

Look hard at your open jobs. Know which ones are billed ahead and which are behind, because that gap is sitting in your taxable income whether you track it or not.

Then run a projection off the job-costed number, not the bank balance. That is the figure that tells you what is worth doing in the next six weeks and what will just cost you cash.

Clean job costing will not lower your taxes by itself. It is the thing that makes every strategy that does lower them actually possible. You cannot time equipment, set owner pay, or defer income on numbers you do not trust.

If your books tell you what is in the account but not which jobs made money, that is the conversation worth having before the year closes.

Schedule a call at buildandsavetax.com/contact. We will look at how your jobs are costed, show you what your real year looks like, and tell you which moves are still on the table before December 31.

Next
Next

The Year-End Question a CPA for Home Remodelers Asks Before December 31